As you’re going about your daily laundromat operations, you probably noticed something’s wrong with your commercial laundry equipment. Or, you want to take the initiative and prevent your equipment from shutting down when it’s too late to repair with commercial laundry parts from stores like Laundry Replacement Parts.
Either way, it’s worth knowing these common commercial laundry equipment. Here are the things you must know!
1. The washer isn’t filling with water
If you notice this problem, you must address it immediately and check the inlet hose. First, check if the washer in the hose is damaged or if there’s just a kink. If you notice a leak in the hose, you can install a temporary patch before replacing the entire inlet hose.
While installing the new inlet hose using dexter laundry parts, make sure you keep the hose straight, preventing any potential damage later on.
2. Water won’t stop running
If this happens, you should check the overflow switch right away. The switch would detect when the washer tub is full, automatically stopping water flow.
Before you try installing a replacement overflow, check if this switch is disconnected. If so, you can simply reconnect it and see if that did the trick.
3. The tup fills with water but doesn’t spin
Before checking any parts in the machine, try to adjust the load. If the garments are packed too tight in the tub, that will affect the machine’s ability to spin.
If the clothes are fine, inspect the lid safety switch, which is usually found beneath the main top, having a protruding protective lid. That switch would supply power to the timer and motor circuits, activating once the lid properly closes. Tripped switches would either require reconnection or replacement.
4. Your washer won’t drain
This problem would happen when the machine’s drain pump is clogged or damaged. That becomes a significant issue because if water isn’t drained from the tub, the machine won’t head to the next step of its cycle.
What you should do is first check if any small items are stuck in the drain pump. If there is no clogging or anything stuck, then it may be the drain pump itself that’s damaged and requires replacement.
5. The dryer doesn’t emit enough heat for drying clothes
Electric dryers would rely on heating elements to successfully produce enough heat to dry clothes. That’s the first and only thing you should inspect if this issue occurs.
Heating elements are built with a heating coil wire enclosed in metal protective housings. Inspect this by unplugging the dryer and removing the front or rear panels until you see the heating element. Test the heating element using a multi-meter. If it’s defective, then that part will require replacement.
Wrapping It Up
If ever you have tried to remedy the problems above, but nothing works, it’s best to hire a repairman in hopes of getting your equipment up and running again properly.